How to Store a Jon Boat During Winter: 5 Easy Steps
Learn how to store a jon boat during winter with simple steps that protect your boat, save money, and keep you ready for spring.
Estimated Time: 2‑3 hours. Difficulty: Easy. Primary Objective: Shield the hull, engine, and gear from ice, moisture, and critters.
Ready to give your jon boat a safe winter home? Follow these clear steps and avoid costly repairs.
Tools, Gear & Preparation
| Item / Tool | Purpose | Optional / Required |
|---|---|---|
| Boat cover or tarp | Shields hull from snow and UV | Required |
| Marine‑grade straps or ropes | Holds cover tight | Required |
| Cleaning brush and mild soap | Removes dirt, algae, salt | Required |
| Fuel stabilizer | Keeps fuel fresh | Required |
| Battery charger or maintainer | Prevents battery drain | Required |
| Jack stands or blocks | Lifts boat off ground | Optional |
| Water pump or bilge pump | Removes standing water | Optional |
| Gloves and safety glasses | Protects you while cleaning | Required |
Work on a flat, dry surface. Disconnect shore power if the boat is on a trailer. Choose a calm day with no rain or strong wind.
Step 1: Clean the Boat Thoroughly
Rinse the hull with fresh water. Use a soft brush and mild soap to scrub away grime.
Pay special attention to the transom, keel, and any rivets. Salt and algae can cause corrosion if left over winter.
Rinse again until no suds remain. Let the boat air dry completely before moving to the next step.
Captain’s Note: A quick spray of vinegar on stubborn stains helps break down mineral deposits without harsh chemicals.
Do you see any cracks or soft spots in the hull? Mark them now for repair before storage.
Step 2: Drain Water and Add Fuel Stabilizer
Open the drain plug and let all water out of the bilge and livewell. Tilt the boat slightly to help water flow out.
If your boat has a built‑in fuel tank, add the recommended amount of fuel stabilizer to the tank.
Run the engine for 5‑10 minutes so the treated fuel circulates through the carburetor or fuel injectors.
Turn off the engine and close the fuel vent. This step prevents fuel from gumming up during cold months.
Trail Hack: Write the date and amount of stabilizer on a piece of tape and stick it on the fuel cap for easy reference.
Step 3: Protect the Engine and Battery
Spray a light coat of corrosion inhibitor on the engine’s external parts. Focus on bolts, brackets, and the propeller shaft.
Remove the battery if possible. Clean the terminals with a wire brush and apply a thin layer of petroleum jelly.
Store the battery in a cool, dry place and connect it to a maintainer to keep it charged.
If you cannot remove the battery, leave the maintainer hooked up and check the charge monthly.
Do you hear any unusual noises when you crank the engine? Address them now to avoid surprises in spring.
Step 4: Cover the Boat Securely
Spread the boat cover or tarp over the hull, making sure it overlaps the gunwales by at least 6 inches.
Pull the cover tight and secure it with marine‑grade straps or ropes. Use quick‑release buckles for easy removal later.
Check that no water can pool on top of the cover. If needed, place a few foam blocks or pool noodles under the cover to create a slope.
Make sure the cover does not rub against sharp edges that could tear it.
Captain’s Note: A breathable cover reduces mildew buildup while still keeping snow out.
Step 5: Final Checks and Storage Spot
Walk around the boat and look for loose straps, tears in the cover, or any standing water.
Place the boat on jack stands or blocks if you have them. This keeps the hull off the ground and improves airflow.
Choose a storage spot that is shaded, dry, and protected from strong winds. A garage, shed, or dedicated boat storage works best.
Label the cover with your name and contact info in case it shifts during a storm.
Now your jon boat is ready to wait out the winter safely.
Common Mistakes & Troubleshooting
Problem: Water collects under the cover and freezes.
Cause: The cover is too tight or low spots allow pooling.
Quick Fix: Re‑adjust the straps to create a slight slope. Add foam pads under the cover to lift low areas.
Problem: Battery dies despite being on a maintainer.
Cause: Loose connections or a faulty charger.
Quick Fix: Clean the terminals again, check the charger’s output with a multimeter, and replace if needed.
Problem: Mildew appears on seats or storage compartments.
Cause: Cover is not breathable or boat was stored damp.
Quick Fix: Air out the boat on a dry day, wipe surfaces with a mild vinegar solution, and use a breathable cover next year.
Frequently Asked Questions About How to Store a Jon Boat During Winter
How often should I check the cover during winter?
Check the cover after each heavy snow or wind event. Look for tears, loose straps, or water buildup and fix them right away.
Can I leave fuel in the tank over winter?
Yes, if you add a quality fuel stabilizer and run the engine briefly to distribute it. This prevents fuel from breaking down.
Is it necessary to remove the propeller?
No, but you should inspect it for damage and apply a light coat of corrosion inhibitor to the shaft.
What if I don’t have a garage?
Use a sturdy, breathable tarp and secure it well. Choose a spot that is off the ground and away from direct snow drifts.
Should I wax the hull before storage?
A light wax coat adds extra protection against UV and moisture, but it is not required if you use a good cover.
Final Thoughts
Your jon boat is now clean, dry, and shielded from winter’s harsh elements. Follow these steps each year and you’ll save time, money, and hassle when spring arrives.
Get out there, enjoy the off‑season planning, and hit the water confidently when the ice melts.