how to check life jacket expiration: 5 Tips

How to Check Life Jacket Expiration: A Step-by-Step Guide

how to check life jacket expiration

Do you know how to check life jacket expiration? It’s a vital skill—an aging jacket simply won’t keep you afloat. The Coast Guard requires a serviceable PFD on board, and a compromised one puts everyone at risk. This guide walks you through the exact steps: reading the label, spotting wear, and knowing when it’s time to replace it.

Estimated Time: 10 minutes
Difficulty Level: Easy
Primary Objective: Confirm your life jacket is safe and legal

Before You Start: Tools, Gear & Preparation

Gather a few basics: good light, a flat surface to lay the jacket out, and a magnifying glass for tiny date codes. A pen and paper (or your phone) let you record dates for each vest.

Item / Tool Purpose Optional / Required
Bright flashlight or daylight Read small label text Required
Flat table or clean deck Lay jacket flat for inspection Required
Magnifying glass See tiny date codes Optional
Pen and notebook Record dates for each jacket Optional
Camera or phone Photo label for records Optional

Safety Check: Do this on dry land. Make sure the jacket is clean and dry—wet fabric hides tears. Empty the pockets before you begin.

Step 1: Locate the Label

Every approved jacket carries a label, usually sewn or heat-sealed inside near the neck or along a side seam. Turn the vest inside out if you need to. The tag is typically white with black printing and feels stiffer than the surrounding fabric.

Run your hand along the inner lining until you feel that stiff tag. If it’s not inside, check the outer shell near the bottom hem—some brands place it there instead.

Captain’s Note: Snap a photo of the label and zoom in on your phone. It spares your eyes and gives you a permanent record.

Step 2: Find the Date Code

Scan for a line reading “MFG” or “MANUFACTURED.” Next to it you’ll find a date—usually month and year (e.g., “03/2022” for March 2022). Some manufacturers use a coded format like “2203” for year 2022, week 03.

Read the code slowly, say each number aloud, and write it down. No guessing. If the print has faded, shine your flashlight at a low angle across the label; the raking light catches the raised ink.

Spot other numbers? Those are typically lot or model codes. Only the manufacture date matters for determining age.

Step 3: Understand the Life Span

Most foam PFDs have a 10-year service life from the manufacture date. Inflatables generally run 5–10 years. Check the label for a “Service Life” line or a “Replace by” date—some brands print it outright.

If there’s no replace-by date, do the math: add 10 years for foam, 5 for inflatable. Circle that future date on your calendar now.

Ask yourself: has that date passed? If yes, the jacket is expired and must be replaced.

Step 4: Inspect for Physical Damage

Age isn’t the only killer—a brand-new vest can fail if it’s damaged. Lay it flat and run your hands over every inch. Feel for tears, burns, or holes. Check every seam; tug gently on the stitching—it shouldn’t give.

Test every buckle: click it, then pull the strap hard. It has to hold. Zippers should run smooth and stay closed under tension.

Look for fading—UV rot weakens fabric until you can tear it by hand. Check for mold or mildew spots, and give it a sniff. A musty smell means deep contamination.

Step 5: Check Flotation Material

**Foam vests:** Squeeze each panel. It should rebound instantly. If the dent stays, buoyancy is gone. Crumbling foam fails—break off a tiny hidden piece if you’re unsure; it shouldn’t disintegrate like old sponge.

**Inflatables:** Check the CO₂ cylinder—screwed in tight? The indicator window should show green (armed), not red (spent/missing). Unscrew the cylinder and weigh it on a kitchen scale. Compare the reading to the “Full Weight” stamped on the cylinder; if it’s light, replace it.

Inspect the inflator mechanism: pull the manual cord—the pin should move freely. No rust on the bobbin or pill. A yellow or soft bobbin means it’s time for a re-arm kit.

Step 6: Verify Coast Guard Approval

The label must read “USCG Approved” with an approval number (e.g., 160.064). That number confirms federal compliance. No legible label? The jacket isn’t legal and can’t count toward your required carriage.

You’ll also see Type I, II, III, or V printed on the tag. Know which type your boat and activity require—Type III is standard for recreation; Type V covers special uses. Match the type to your needs.

Step 7: Record and Decide

Log each jacket: serial number, manufacture date, and your verdict. Keep it simple: “Jacket 1 – MFG 04/2018 – Foam – Good – Replace by 04/2028.”

If it’s expired, damaged, or fails any test, mark it “REPLACE.” Cut the straps so nobody grabs it by mistake, toss it in the trash, and buy a new approved PFD before your next outing.

If it passes, return it to its storage spot—accessible, not buried under gear or sealed in a bag.

Common Mistakes & Troubleshooting

Problem: You confuse the manufacture date with an expiration date.
Cause: Labels rarely print “Expires.” They print “MFG.”
Quick Fix: Add the service-life years to the MFG date. That’s your true expiration.

Problem: The label is faded or missing.
Cause: Sun, washing, or wear erased the print.
Quick Fix: No label means not legal. Replace the jacket—don’t guess.

Problem: You assume a jacket that looks fine is good to go.
Cause: Foam fails internally where you can’t see it.
Quick Fix: Always squeeze-test foam. Always weigh CO₂ cylinders. Trust the test, not the look.

Problem: Inflatable indicator shows green but the jacket won’t inflate.
Cause: Bobbin expired or cylinder empty.
Quick Fix: Check the bobbin date. Weigh the cylinder. Replace the re-arm kit annually or per manufacturer specs.

Frequently Asked Questions About How to Check Life Jacket Expiration

How often should I check my life jackets?

Do a full inspection at the start of every season, a quick visual before each trip, and a thorough check once a year.

Can I use a life jacket past the 10-year mark if it looks good?

No. Foam degrades from the inside out. The Coast Guard sets a 10-year maximum for foam; inflatables have even shorter limits. Replace on schedule.

Where is the expiration date on an inflatable life jacket?

There usually isn’t one. Find the manufacture date on the label, then check the CO₂ cylinder and bobbin dates—those components expire sooner.

What do I do with an expired life jacket?

Cut the straps, write “EXPIRED” in marker, and put it in household trash. Don’t donate it. Don’t keep it as a spare.

Does a life jacket expire if never used?

Yes. Time, heat, and humidity break down materials whether you wear the vest or not. Follow the same replacement timeline.

Final Thoughts

You now know how to check life jacket expiration. Ten minutes. Zero cost. Could save your life. Make it a habit—check every jacket on your boat, your kids’ vests, your guests’ gear. A good PFD floats you; a bad one doesn’t. Be sure. Be safe. Get out on the water with confidence.

Leave a Comment